Avaya IP500 V2 Operations Instructions download pdf (Page 100)

Installing IP500/IP500 V2 Page 100

15-601042 Issue 28g (11 October 2013)IP Office 9.0

4.13.4 TCM Phones

Connect any TCM phones to their appropriate TCM ports. These phones do not need to load additional firmware.

DS30B Module

The IP500 DS16B and DS30B external expansion modules support either TCM or DS ports. The port type for a whole

module is configured using IP Office Manager. See DS16B/30B Port Mode Selection .

Default Buttons

For system's with TCM phone ports, when a phone is first connected to the port, the button programming of the

associated user is overwritten with the default button programming appropriate for the phone model.

If the new system is being installed with a pre-staged configuration that include user button programming, the automatic

defaulting of buttons to match the phone type will overwrite the user button settings. This behavior can be prevented by

adding the following short code to the user's setup in the pre-programmed configuration:

· Code: *DCP

· Feature: Dial

· Telephone Number: 84000004,1,1,0

The 4000004 part of the string above can also be used to adjust the defaults for the following phone settings:

· The first digit sets the phone contrast = 1 (low) to 9 (high).

· The last digit sets the ringer volume = 0 (high) to 7 (low).

Note that subsequently removing this short code will cause the buttons to return to defaulting according to the phone

type.

Phone Type Setting

For some phones, the phone can only report its general type to the system rather than its specific model. It is

recommended that after connecting all the phones, the phone types should be correctly set in the IP Office configuration.

· ! Important

The default types cannot be changed after installation without defaulting the configuration. Therefore you must

ensure that you connect the correct type of phone to each port. If you need to swap phones, uses the process for

exchanging extension numbers rather than swapping wiring.

1.Using IP Office Manager, receive the configuration from the system.

2.Select Extension.

3.Selecting each extension in turn, on the Extn tab, check that the Device Type field is set to the correct phone

model.

Default Type

Possible Phone Models

T7100

T7100, MT7100, MT7100N, Audio Conferencing Unit.

T7208

T7208, MT7208, MT7208N.

M7310

T7406E, T7406, M7310, M7310N

M7310BLF

T7316, M7310BLF

M7324

M7324, M7324N

4.Save the configuration back to the IP Office system.

4.13.5 IP/SIP Phones

The installation and configuration of H323 and SIP IP telephones is not covered by this document. Refer to the

appropriate IP Office installation manual for the type of phone being installed.

115

168

1 2 ... 95 96 97 98 99 100 101 102 103 104 105 ... 441 442

Comments to this Manuals

No comments

Avaya IP500 V2 Operations Instructions Page 100

Comments to this Manuals

Related products and manuals for Gateways/controllers Avaya IP500 V2