Avaya IP500 V2 Operations Instructions download pdf (Page 83)

Installing IP500/IP500 V2 Page 83

15-601042 Issue 28g (11 October 2013)IP Office 9.0

IP500 V2 Installation: SD Card Preparation

4.5 IP500 Card Installation

The IP500 base cards and trunk daughter cards should be fitted before power

is applied to the control unit. Ensure that cards are inserted in the order that

matches the planned or pre-built configuration.

This process has 3 stages:

1.Fit the IP500 trunk daughter cards onto the IP500 base cards.

2.Fit any IP400 Legacy Cards onto a Legacy Card Carrier.

3.Insert the IP500 Base Cards into the Control Unit.

· Warnings

· Correct anti-static protection steps should be taken before handling circuit boards.

· Cards must never be added or removed from the control unit while it has power connected.

· General Notes

· Cards can be fitted in any order into any available slots. The only exception is the IP500 4-Port Expansion

card which can only be installed in right hand slot 4.

4.5.1 Fitting IP500 Daughter Cards

IP500 trunk daughter cards can be fitted to any IP500 base card except the IP500 Legacy Card Carrier. For IP500

Combination cards, the trunk daughter card is pre-installed and cannot be changed.

Warnings

1.Correct anti-static protection steps should be taken while

handling circuit boards.

Parts and Equipment Required

1.o IP500 Base Card (except the IP500 Legacy Card Carrier).

2.o IP500 Trunk Daughter Card

3.o 3 Stand Off Pillars

These are supplied with the trunk daughter card.

Tools Required.

1.o 5mm Flat-blade screwdriver.

2.o Anti-static wrist strap and ground point.

Procedure: Installing a Trunk Daughter Card

1.Check that correct cards have been supplied.

2.Ensure that you are wearing an anti-static wrist strap connected

to a suitable ground point.

3.On the base card identify the position of 3 holes for the plastic

pillars for the IP500 card. These are along the same edge as the

card connector.

4.Fit the stand off pillars to the IP500 base card.

5.If there is a clip-on metal shield over the connector block on the

base card, remove it.

6.Using minimal force and checking that the pins are correctly

located, push the IP500 trunk card onto its connector block and

the stand off pillars.

7.Check that the card connector has snapped into position.

1 2 ... 78 79 80 81 82 83 84 85 86 87 88 ... 441 442

Comments to this Manuals

No comments

Avaya IP500 V2 Operations Instructions Page 83

Comments to this Manuals

Related products and manuals for Gateways/controllers Avaya IP500 V2