Avaya IP500 V2 Operations Instructions download pdf (Page 112)

Installing IP500/IP500 V2 Page 112

15-601042 Issue 28g (11 October 2013)IP Office 9.0

5.7 Setting the Digital Trunk Clock Source

Digital trunks require the telephone system at each end of the trunk to share a clock signal to ensure synchronization of

call signalling. The IP Office can obtain and use the clock signal from any of its digital trunks. Typically the clock signal

provided by a digital trunk from the central office exchange is used as this will be the most accurate and reliable clock

source.

To do this, the Clock Quality setting on each line in the IP Office configuration is set to one of the following:

· Network

If available, the clock signal from this trunk should be used as the IP Office's clock source for call synchronization.

If several trunk sources are set as Network, the IP Office will default to using one as detailed below.

· Fallback

If available, the clock signal from this trunk can be used as the clock source if none of the trunks set as Network

are providing a clock source.

· Unsuitable

The clock source from this trunk will never be used as the IP Office's clock source.

If no clock source is available the IP Office can use its own internal clock if necessary.

In the example below the first IP Office is set to use the public network trunk as its clock source and ignoring the possible

clock source from the QSIG trunk. The other IP Office system is using the clock signal received from the first IP Office on

its QSIG trunk as its clock source. Thus both IP Offices are using the same clock source and that clock source is the

public network exchange.

Multiple Source Priority

When multiple trunks with the same setting are providing clock signals, the trunk used is determined in the following

order of priority.

· IP500 and IP500 V2 Control Units: Trunks are used in the order of slots 1 to 4 and then by port on each slot.

Viewing the Current Clock Source

The current clock source being used by an IP Office system is shown on the Resources page within the System Status

Application.

1 2 ... 107 108 109 110 111 112 113 114 115 116 117 ... 441 442

No comments

Avaya IP500 V2 Operations Instructions Page 112