Avaya IP500 V2 Operations Instructions download pdf (Page 236)

Installing IP500/IP500 V2 Page 236

15-601042 Issue 28g (11 October 2013)IP Office 9.0

10.4.1 Analog Trunk Card

These cards can be added to an IP500 base card to provide that card with support for 4 loop-start analog trunks. The

newer IP500 Analog Trunk Card V2 version is supported by IP500 V2 systems running IP Office Release 8.1 Feature Pack

1 or higher only.

This card can be fitted to any IP500 base card except the IP500 Legacy Carrier card and IP500 4-Port Expansion card.

· IP500 Control Unit - V1: , V2:

· IP500 V2 Control Unit - V1: , V2:

· Ports/Channels

4 Loop-start analog trunk ports. Connections via the host IP500 base card.

· DTMF, ICLID and busy tone detection.

· Over-voltage/lightning protection (may still require additional protection

equipment ).

· DTMF and LD (loop disconnect) dialing.

· Echo cancellation.

· Echo Cancellation

The card supported echo cancellation that varies depending on the card

type.

· V1: Echo cancellation manually selectable to either 8, 16, 32, 64 or

128 milliseconds or Off. The default is 16 milliseconds.

· V2: Echo cancellation manually selectable to either On or Off. The

default is On. The IP500 Analog Trunk Card V2 also supports echo

reduction which is set to On by default.

· Service Status/Line Status Indication

· V1: Detection of individual line status for idle lines is not supported.

Therefore, the card LEDs and System Status Application simply indicate

that the card is installed and when the line is in use.

· V2: Automatic detection of line status for idle lines is supported. The

card LEDs and System Status Application indicate that the individual

line is connected and idle or is in use.

· Impedance Matching

· V1: For this card only manual impedance matching is useable and only

in selected locales.

· V2: This card supports automatic impedance matching at system

startup and this mode is enabled by default. Manual or no impedance

matching can be used if required. Impedance matching is supported in

all locales.

· Power Failure Port

Regardless of the IP500 card hosting it, during power failure pins 4 and 5

of port 12 are connected to pins 7 and 8. In addition, when fitted to an

IP500 Analog Phone 8 base card, during power failure extension port 8 is

connected to the analog trunk port 12.

· License: No license required.

· Maximum per Control Unit: 4.

· IP Office Software Level:

This depends on the version of the card as follow:

· V1: 4.0+. IP500 and IP500 V2.

New build PCS10 and higher cards are only supported in systems

running IP Office Release 6.1(20), 7.0(12) or 8.0 and higher. Refer to

IP Office Technical Tip 237.

· V2: 8.1 Feature Pack 1+, IP500 V2 only.

1 2 ... 231 232 233 234 235 236 237 238 239 240 241 ... 441 442

Comments to this Manuals

No comments

Avaya IP500 V2 Operations Instructions Page 236

Comments to this Manuals

Related products and manuals for Gateways/controllers Avaya IP500 V2