Installing IP500/IP500 V2 Page 251
15-601042 Issue 28g (11 October 2013)IP Office 9.0
System Components: IP500 External Expansion Modules
10.5.5 Digital Station 16B/30B
This type of module can be used to add additional RJ45 DS or TCM ports to an IP Office system (DS only on IP500
control units). However, each module only supports DS ports or TCM ports, a module cannot support a mix of ports. The
type of ports supported by a module is set through the IP Office system configuration. See DS16B/30B Port Mode
Selection .
The modules are available in 16 and 30 port variants, referred to as the IP500 DS16B and IP500 DS30B respectively.
· For IP Office Release 8.0 and IP Office Release 8.1 systems, these modules only support DS ports.
· These modules only support the following DS phones: 1400 Series, 2400 Series, 3800 Series, 5400 Series and
9500 Series.
IP500 (DS only) and IP500 V2 (DS or TCM).
Supported in all IP Office locales .
TCM Port Connections: IP Office core software level 9.0. Bin file = nadcpaV2.bin.
DS Port Connections: IP Office core software level 8.0. Bin file = nadcpaV2.bin.
Power supply unit (see below) and Expansion Interconnect cable.
The module is supplied with a Earthed 3-Pin, 60W external power supply module. The PSU has an
integral power cord for connection to the module's DC I/P socket. A locale specific IEC60320 C13
power cord for the external PSU is required but is not supplied with the module.
The module is designed as a free-standing module that can be stacked on or under other IP Office
modules. The module can be wall or rack mounted using the IPO IP500 RACK MNTG KIT V3 .
Width: 445mm/17.5". Depth: 245mm/9.7". Height: 71mm/2.8".
Unboxed: 3.5Kg/7.8lbs. Boxed: 4.8Kg/10.8lbs. (Based on DS30)
Module Front
· Green Flashing = Phone detected.
· Green On = Phone active.
The center LED on all external expansion modules is used to indicate the overall state of the module as
follows:
· Red flashing = Module starting up/Loading firmware.
· Red on = Error.
· Green on = Module okay.
394 402
115
51
39
279
Comments to this Manuals