Avaya IP500 V2 Operations Instructions download pdf (Page 102)

100

101

Installing IP500/IP500 V2 Page 102

15-601042 Issue 28g (11 October 2013)IP Office 9.0

5. Initial Configuration Using IP Office Manager

This section covers basic configuration changes required for IP Office systems if using the IP Office Manager application.

This covers just the basic configuration, the full range of configuration possible through IP Office Manager is covered in

the IP Office Manager manual.

1.Enter Licenses

Enter licenses for features that require them.

2.Set the System Locale

Setting the correct system locale affects a wide range of settings including trunk settings. The correct locale must

be set for a system to operate correctly.

3.Set the Extension Numbering

Renumber the user extensions if required.

4.Change the Default Passwords

The default passwords used for configuration access to the IP Office system should be changed.

5.Change the IP Address/DHCP Settings

If necessary, the IP address and DHCP mode of the IP Office system can be changed.

6.Remove any Unused Trunks

Disabling the use of trunks and trunk channels that are not available.

7.Select the Clock Source for Digital Lines

Altering which digital trunk is used to provide the IP Office with its clock signal for call synchronization.

8.Enter Trunk Prefixes

On systems where a prefix is being used for external dialing, ensure that the same prefix is added to incoming

numbers in order to allow return calls.

9.DS16B/30B Port Mode Selection

These modules can support Avaya T-Series and M-Series phones by providing TCM ports or other Avaya digital

phones by providing DS ports. The port type selection for the whole module is done using IP Office Manager.

103

104

108

106

105

110

112

114

115

1 2 ... 97 98 99 100 101 102 103 104 105 106 107 ... 441 442

Comments to this Manuals

No comments

Avaya IP500 V2 Operations Instructions Page 102

Comments to this Manuals

Related products and manuals for Gateways/controllers Avaya IP500 V2